Windscreen wipers
If the wiper arms were dismantled Transporter T4 , then during installation it is necessary to ensure their correct position.
In the off state, the brushes should take the position shown in fig. 535. The moment of an inhaling of a nut of fastening of the lever of 16 Nm. The device and arrangement of the mechanism of a forward screen wiper see fig. 537. If you need to dismantle / disassemble the mechanism, use this figure.
Rice.
534 Rear door wipers T4 - single-leaf rear door 1 - brush, 2 - lever, 3 - spring washer, 4 - articulated lever with rod, 5 - connecting tube for washer nozzle, 6 - hose, 7 - electric motor, 8 - motor bracket, 9 - rubber ring, 10 - bushing, 11 - bolt Mb, 5Nm, 12 - bolt Mb, 5Nm, 13 - sealing ring, 14, 15, 18, 20 - washers, 16 - retaining ring, 17 - plastic washer, 19 - nut M16.10 Nm, 21 - nut M8, 16Nm, 22 - washer nozzle 23 - protective cap
Rice. 535 Windshield wiper arm position
Rear door wipers T4
♦ Position the wiper blade at the height of the lowest wire of the heated rear window heating element: dimension (a, see Fig. 536) is 45 mm. When performing a car with rear hinged doors, set the lever so that the brushes in the initial state are in a vertical position. The device and arrangement of the mechanism of a screen wiper see fig. 534 and 538.
Rice. 536 position of the rear door glass wiper
Rice.
537 Windshield wiper Transporter T4 windshield 1 - brush, 2 - lever, 3 - protective cap 4 - hex nut, 16 Nm, 5 - washer, 6 - hex bolt, 5 Nm, 7 - rubber insert, 8 - spacer, 9 - bolt, 25 Nm, 10 - tie rod, 11 - self-locking nut, 13 - wiper motor, 14 - articulated arm, 15 - spring washer, 16 - housing, 17 - o-ring, 18 - washer, 19 - washer, 30 - retaining ring, 51 - plastic washer, 22 - spacer ring
Rice.
538 Rear door wipers - double doors: 1 - brush, 2 - lever, 3 - washer nozzle, 4 - protective cap, 5 - M8 nut, 16Nm, 6 - M16 nut, 10Nm, 7, 10, 11, 13, 20 - washers, 8 - plastic washer, 9 - retaining ring, 12 - sealing ring, 14 - shaft bracket, 15 - spring washer, 16 - hinged lever, 17 - washer connecting tube, 18 - hose, 19 - sleeve, 21 - electric motor, 22 - bolt with washer, 23 - motor bracket, 24 - gear washer, 25 - crank 26 - Mb bolt, 5Nm, 27 - M8 nut, self-locking, 28 - articulated rod